Users Guide

Managing General System Settings 463
Viewing Slot Information (Dell EMC Networking N4000 Series Only)
Use the following commands to view information about Slot 0 and its
support.
Configuring PoE Settings (Dell EMC Networking N1108P-ON/
N1124P-ON/ N1148P-ON, N1524P/N1548P, N2024P/N2048P/N2128PX-ON,
N3024P/N3048P/N3132PX-ON Only)
Use the following commands to configure PoE information.
Command Purpose
show slot Display status information about the expansion slots.
show supported cardtype Display information about the modules the switch
supports.
Command Purpose
configure Enter Global Configuration mode.
power inline usage-
threshold
threshold
[unit unit-id ]
Specify the maximum usage for PoE power on the switch
or the specificed stack unit. The threshold variable (range:
1–99%) is a percentage of total system power.
power inline
management [unit
unit-
id ] {class | static |
dynamic}
Set the power-management mode for the switch or the
specificed stack unit.
power inline detection
[unit
unit-id ] {dot3at |
dot3at+legacy-only}
Set the power-management mode for the switch or the
specificed stack unit.
• dot3at —IEEE 802.3at detection scheme is used.
•
dot3at+legacy-only —IEEE 802.3at 4point detection
scheme is used and when it fails to detect a connected
PD, legacy capacitive detection is used.
interface interface Enter interface configuration mode for the specified port.
The interface variable includes the interface type and
number, for example gigabitethernet 1/0/3.