Users Guide

1514 Differentiated Services
Configuring DiffServ (CLI)
This section provides information about the commands used for configuring
DiffServ settings on the switch. For more information about the commands,
see the
Dell EMC Networking N1100-ON, N1500, N2000, N2100-ON,
N3000, N3100-ON, and N4000 Series Switches CLI Reference Guide
at
www.dell.com/support.
DiffServ Configuration (Global)
Use the following commands to configure the global DiffServ mode and view
related settings.
DiffServ Class Configuration for IPv4
Use the following commands to configure DiffServ classes for IPv4 and view
related information.
CLI Command Description
configure Enter global configuration mode.
diffserv Set the DiffServ operational mode to active.
exit Exit to Privileged Exec mode.
show diffserv Display the DiffServ general information, which
includes the current administrative mode setting as
well as the current and maximum number of
DiffServ components.
CLI Command Description
configure Enter global configuration mode.
class-map match-all
class-map-
name
Define a new DiffServ class and enter Class-Map
Configuration mode for the specified class.
NOTE: To enter Class-Map Configuration mode for a
class that has already been created, use the class-
map
class-map-name command.
match any Configure a match condition for all the packets.
match class-map Add to the specified class definition the set of
match conditions defined for another class.