Setup Guide
Table Of Contents
- Introduction
- N1108T-ON/N1108P-ON/N1108EP- ON Installation
- N1124T-ON/N1124P-ON/N1148T-ON/ N1148P-ON Installation
- Starting and Configuring the N1100-ON Series Switch
- Agency compliance
- NOM Information (Mexico Only)
12 Getting Started Guide
Figure 1-4. Inserting Mounting Brackets
4
Repeat the process for the wall-mounting bracket on the other side of the
switch.
5
Place the switch on the wall in the location where the switch is being
installed.
6
Mark the locations on the wall where the screws to hold the switch must be
prepared.
7
On the marked locations, drill the holes and place all the eight supplied
anchors in the holes.
8
Insert the supplied screws into the wall-mounting bracket holes and
tighten them with a screwdriver. See Figure 1-5.