Setup Guide
Table Of Contents
- Introduction
- N1108T-ON/N1108P-ON/N1108EP- ON Installation
- N1124T-ON/N1124P-ON/N1148T-ON/ N1148P-ON Installation
- Starting and Configuring the N1100-ON Series Switch
- Agency compliance
- NOM Information (Mexico Only)
Getting Started Guide 11
Figure 1-3. Install on a Two-post Rack with L-Bracket
Mounting all N11xx-ON Switches on a Wall
1
Make sure that the mounting location meets the following requirements:
• The surface of the wall can support the switch.
• The location is ventilated to prevent heat buildup.
NOTE: You can mount the N1108P-ON and N1108T-ON on the wall with the I/O side
facing the left side, the right side, or up.
2
Place the supplied wall-mounting bracket on one side of the switch,
verifying that the mounting holes on the switch line up to the mounting
holes on the wall-mounting bracket.
3
Insert the supplied screws into the wall-mounting bracket holes and
tighten with a screwdriver. See Figure 1-4.