Release Notes

Known Issues 13
Issue ID Functional
Area
Description Workaround/Resolution
MDT-211358
Connectivity-
Networks
TDIP stopped advertising on PowerStore
3000X model.
Perform either one of the following actions
to workaround this issue:
Either, wait a few minutes for the state of
the system to change and try again.
or
Reset Drive, Mezz or I/O Module if available
and wait for few minutes and try again, then
reboot the primary node.
MDT-55667 Data Collection
Storage container capacity metrics are not
available until I/O operations have begun.
Look at the capacity metrics again after I/O
operations on the storage container have
been performed.
MDT-220994 Data Protection
The replication session may not be
deleted once a Protection Policy is
unassigned from the storage resource.
To delete the replication session, do the
following:
1. If Protection Policy is not assigned to the
storage resource, reassign the the same
Protection Policy that was previously
assigned to the storage resource.
2. Unassign the Protection Policy from the
storage resource.
MDT-133408 Data Protection
When a volume group is created with
member volumes and is protected by a
protection policy that includes a
replication rule, the volume group
members may be delayed in being
replicated to the remote system until the
next RPO cycle. The default replication
rule RPO value in PowerStore Manager is
1 hour, but it can range from 5 minutes to
24 hours.
If the remote system connection is healthy,
the member volumes should automatically
be replicated to the destination during the
next RPO cycle. To update the member
volumes on the destination before the next
RPO cycle, navigate to Protection->
Replication, select the volume group session
and perform a "Synchronize" operation.
MDT-146780 Data Protection
When deleting a snapshot rule, the
snapshot rule may not appear to be
deleted, and the following error appears:
"The system encountered unexpected
backend errors. Please contact support.
(0xE0101001000C)". Do not continue
using the rule for protection.
Delete the snapshot rule again. The same
error appears, but the rule will be deleted.
MDT-117061 Hardware
When beginning cluster creation, the
hardware status is incorrectly indicated as
not configured for clustering.
Wait a few minutes and try again.