Dell EMC PowerEdge XR2 Technical Specifications Regulatory Model: E48S Series Regulatory Type: E48S001 May 2020 Rev.
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2017 - 2020 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents 1 Dell EMC PowerEdge XR2 overview................................................................................................4 2 PowerEdge XR2 technical specifications........................................................................................ 5 System dimensions................................................................................................................................................................5 Chassis weight................................................
1 Dell EMC PowerEdge XR2 overview The PowerEdge XR2 is a 1U, dual socket rack system with 8 x 2.5-inch drives and supports up to: • • • • • Two Intel ® Xeon ® Processor Scalable Family processors 16 DIMM slots Integrated M.2 module Optional M.2 based Boot Optimized Storage Solution module Two redundant power supply units (PSU) NOTE: All instances of SAS/SATA hard drives/SSDs and NVMe SSDs are referred to as drives in this document, unless specified otherwise.
2 PowerEdge XR2 technical specifications The technical and environmental specifications of your system are outlined in this section.
Table 1. Dimensions of the PowerEdge XR2 system Xa Xb Y Za (with bezel) Za (without bezel) Zb Zc 482.6 mm (19 inches) 434.0 mm (17.08 inches) 42.8 mm (1.68 inches) 63.15 mm (2.46 inches) 33.9 mm (1.32 inches) 514.35 mm (20.06 inches) 547.4 mm (21.35 inches) Chassis weight Table 2. Chassis weight System Maximum weight (with all drives/SSDs) 8 x 2.5 inch drive system 13.
System battery specifications The PowerEdge XR2 system supports CR 2032 3.0-V lithium coin cell system battery. Expansion bus specifications The PowerEdge XR2 system supports PCI express (PCIe) generation four expansion cards, which must be installed on the system board using expansion card risers. The XR2 system supports four types of expansion card risers. Table 4.
Ports and connectors specifications Common Access Card (CAC) The integrated Common Access Card (CAC) reader or Smart card reader allows for an additional form of authentication for data encryption. The PowerEdge XR2 system supports one CAC on the front panel. USB ports The PowerEdge XR2 system supports: • • USB 2.0-compliant port on the front panel USB 3.0-compliant port on the back panel The following table provides more information about the USB specifications: Table 6.
Table 7. Supported video resolution options Resolution Refresh rate (Hz) Color depth (bits) 640 x 480 60, 70 8, 16, 32 800 x 600 60, 75, 85 8, 16, 32 1024 x 768 60, 75, 85 8, 16, 32 1152 x 864 60, 75, 85 8, 16, 32 1280 x 1024 60, 75 8, 16, 32 1440 x 900 60 8, 16, 32 Environmental specifications NOTE: For additional information about environmental certifications, please refer to the Product Environmental Datasheet located with the Manuals & Documents on www.dell.
Table 12. Maximum altitude specifications Maximum altitude Specifications Operating Mil-Std 810G method 500.6, Proc. II, air carriage, 15,000 ft for 1 hour after stabilization Storage Mil-Std 810G method 500.6, Proc. I, 40,000 ft for 1 hour after stabilization Standard operating temperature Table 13.
• Non-Dell qualified peripheral cards and/or peripheral cards greater than 25 W require engineering analysis to see if they can be supported. For more information or support on non-Dell validated components, contact the OEM sales team. Particulate and gaseous contamination specifications The following table defines the limitations that help avoid any equipment damage or failure from particulates and gaseous contamination.
3 Documentation resources This section provides information about the documentation resources for your system. To view the document that is listed in the documentation resources table: • From the Dell EMC support site: 1. Click the documentation link that is provided in the Location column in the table. 2. Click the required product or product version. NOTE: To locate the product name and model, see the front of your system. 3. On the Product Support page, click Manuals & documents.
Table 17. Additional documentation resources for your system(continued) Task Document Location OpenManage Systems Management Overview Guide. For information about setting up, using, and troubleshooting OpenManage, see the Dell OpenManage Server Administrator User’s Guide. www.dell.com/openmanagemanuals > OpenManage Server Administrator For information about installing, using, and troubleshooting Dell OpenManage Essentials, see the Dell OpenManage Essentials User’s Guide. www.dell.
4 Getting help Topics: • • • • • Contacting Dell Documentation feedback Accessing system information by using QRL Receiving automated support with SupportAssist Recycling or End-of-Life service information Contacting Dell Dell provides several online and telephone based support and service options. If you do not have an active internet connection, you can find contact information about your purchase invoice, packing slip, bill, or Dell product catalog.
Steps 1. Go to www.dell.com/qrl and navigate to your specific product or 2. Use your smartphone or tablet to scan the model-specific Quick Resource (QR) code on your system or in the Quick Resource Locator section. Quick Resource Locator for PowerEdge XR2 Figure 2. Quick Resource Locator Receiving automated support with SupportAssist Dell EMC SupportAssist is an optional Dell EMC Services offering that automates technical support for your Dell EMC server, storage, and networking devices.
