Reference Guide

740 ACL Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\ACL.fm
DELL CONFIDENTIAL – PRELIMINARY 4/3/14 - FOR PROOF ONLY
permit ( MAC )
Use the permit command in MAC Access-list Configuration mode to set
permit conditions (ACEs) for a MAC ACL. Use the no form of the command
to remove the access control entry.
Syntax
permit {any | source source-wildcard} {any | destination destination-
wildcard} [eth-type 0 | aarp | amber | dec-spanning | decnet-iv | diagnostic
| dsm | etype-6000] [vlan vlan-id] [cos cos cos-wildcard] [
time-range time-
range-name]
[log-input]
no permit {any | source source-wildcard} {any | destination destination-
wildcard} [eth-type 0 | aarp | amber | dec-spanning | decnet-iv | diagnostic
| dsm | etype-6000] [vlan vlan-id] [cos cos cos-wildcard] [
time-range time-
range-name]
[log-input]
Parameters
• source —Source MAC address of the packet.
•
source-wildcard —Wildcard bits to be applied to the source MAC address.
Use 1s in the bit position that you want to be ignored.
•
destination —Destination MAC address of the packet.
•
destination-wildcard —Wildcard bits to be applied to the destination
MAC address. Use 1s in the bit position that you want to be ignored.
•
eth-type —The Ethernet type in hexadecimal format of the packet.
•
vlan-id —The VLAN ID of the packet. (Range: 1–4094)
•
cos —The Class of Service of the packet. (Range: 0–7)
•
cos-wildcard —Wildcard bits to be applied to the CoS.
•
time-range-name —Name of the time range that applies to this permit
statement. (Range: 1–32)