Reference Guide

Template Last Updated - 2/7/2007Link Aggregation Control Protocol Commands 607
DELL CONFIDENTIAL – PRELIMINARY 4/3/14 - FOR PROOF ONLY
35
Link Aggregation Control Protocol
Commands
lacp system-priority
Use the lacp system-priority Global Configuration mode command to set the
system priority. Use the no form of this command to restore the default
configuration.
Syntax
lacp system-priority value
no lacp system-priority
Parameters
value—Specifies the system priority value. (Range: 1–65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
Example
The following example sets the system priority to 120.
console(config)# lacp system-priority 120
lacp port-priority
Use the lacp port-priority Interface (Ethernet) Configuration mode
command to set the physical port priority. Use the no form of this command
to restore the default configuration.