Reference Guide

Address Table Commands 423
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 4/3/14 - FOR PROOF ONLY
You can execute the command before the VLAN is created.
Example
Example 1 - The following example registers the IPv6 address to the bridge
table:
console(config)# interface vlan 8
console(config-if)#
bridge multicast ipv6 ip-address
FF00:0:0:0:4:4:4:1
Example 2 - The following example registers the IPv6 address and adds ports
statically.
console(config)# interface vlan 8
console(config-if)#
bridge multicast ipv6 ip-address
FF00:0:0:0:4:4:4:1 add gi0/1-2
bridge multicast ipv6 forbidden ip-address
Use the bridge multicast ipv6 forbidden ip-address Interface (VLAN)
Configuration mode command to forbid adding or removing a specific IPv6
Multicast address to or from specific ports. To restore the default
configuration, use the no form of this command.
Syntax
bridge multicast ipv6 forbidden ip-address { ipv6-multicast-address } {add |
remove} {ethernet interface-list | port-channel port-channel-list}
no bridge multicast ipv6 forbidden ip-address { ipv6-multicast-address }
Parameters
• ipv6-multicast-address —Specifies the group IPv6 Multicast address.
•
add —Forbids adding ports to the group.
•
remove —Forbids removing ports from the group.