Reference Guide

70 Configuring System Information
DELL CONFIDENTIAL – PRELIMINARY 3/6/14 - FOR PROOF ONLY
The following is an example of the output of the CLI command (on the R1-
2210):
System Routing Mode
The R1-2401 device can be in either Layer 2 mode or Layer 2+ Static Routing
mode. The R1-2210 device is always in Layer 2+ Static Routing mode.
To set the system mode of the R1-2401:
1
Click System > General > System Routing Mode in the tree view to
display the
System Mode page.
2 Select either Layer 2 or Layer 2+ Static Routing.
3 Click Apply .
Setting the System Mode Using CLI Commands
The following table summarizes the CLI commands for setting the system
mode.
The following is an example of the CLI commands:
console# show system sensor
Temperature Sensor Type Current Target
Temperature (C) Temperature (C)
----------------------- ----------------------- ----------------
Ambient 1 31 70
Component 1 52 95
Component 2 27 90
Component 3 25 105
Component 4 25 105
Table 7-4. Clock Source CLI Command
CLI Description
set system mode {layer-2-
plus-IPv4-static-routing |
layer-2-only}
Configures the system mode to be router
(Layer 2 + Static Routing or switch (Layer
2).
console# set system mode layer-2-plus-IPv4-static-
routing