Reference Guide

54 Using the CLI
Password Recovery Procedure [3]
The following describe how to access the switch if a user-defined password
has been lost.
To perform password recovery through the Startup menu perform the
following:
1
From the Startup menu select option [3] Password Recovery
and Enter
. Selecting Enter causes the request for the current password
to be ignored after the boot continues.
2 Select [5] Back.
3
The boot process continues and ignores the password prompt.
4 Update password.
NOTE: If the service password-recovery command is enabled, all device
configuration is retained. If the service password-recovery command is disabled,
the switch is restored to the default configuration and uses default settings on the
next boot.
Set Terminal Baud-Rate - Option[4]
To set the terminal baud-rate:
1
Ty p e [4] and press <Enter> .
2 Enter the new baud rate. The following is displayed:
NOTE: After this step, your terminal will no longer respond. Adjust your terminal
speed to the configured one.
Software Download
This section contains instructions for downloading device software (system
and boot images) through a TFTP server. The TFTP server must be
configured before downloading the software.
System Image Download
When the device boots, it decompresses the system image from the flash
memory area and runs it. When a new image is downloaded, it is saved in the
secondary area allocated for the alternative system image copy.
Set new device baud-rate: 38,400