Reference Guide

Quality of Service 497
– Police Type (Only in L2 and R1-2210) — Available in Layer 2 Mode
only. Select the policer type for the policy. The possible options are:
•
None — No policy is used.
•
Single — The policer for the policy is a single policer.
•
Aggregate — The policer for the policy is an aggregate policer.
–
Aggregate Policer (Only in L2 and R1-2210) — Available in Layer 2
Mode only. If Police Type is
Aggregate , select a previously-defined
aggregate policer.
If
Police Type is Single, enter the following QoS parameters:
–
Ingress Committed Information Rate (CIR) (3 - 10485760) (Only in
L2 and R1-2210)
— Enter the CIR in Kbps. See its description in the
Bandwidth pages.
–
Ingress Committed Burst Size (CBS) (3000 - 16769020) (Only in L2
and R1-2210)
— Enter the CBS in bytes. See its description in the
Bandwidth pages.
–
Exceed Action (Only in L2 and R1-2210) — Select the action
assigned to incoming packets exceeding the CIR. The possible options
are:
•
None — No action.
•
Drop — Packets exceeding the defined CIR value are dropped.
•
Out-of-Profile DSCP — Packets, exceeding the defined CIR, are
forwarded with a new DSCP, derived from the
DSCP Mapping
pages.