Reference Guide

Using the CLI 49
NOTE: When using this option, the switch configuration will be restored to factory
default configuration.
Through the Startup Menu
To enter the switch without a password through the Setup Menu, see
Password Recovery Procedure [3].
Configuring Initial Passwords
Initial Telnet Password
To configure an initial Telnet password, enter the following commands:
Initial SSH Password
To configure an initial SSH password, enter the following commands:
Initial HTTP Password
To configure an initial HTTP password, enter the following commands:
Initial HTTPS Password
To configure an initial HTTPS password, enter the following commands:
console(config)# aaa authentication login default line
console(config)# aaa authentication enable default line
console(config)# line telnet
console(config-line)# login authentication default
console(config-line)# enable authentication default
console(config-line)# password bob
console(config)# aaa authentication login default line
console(config)# aaa authentication enable default line
console(config)# line ssh
console(config-line)# login authentication default
console(config-line)# enable authentication default
console(config-line)# password jones
console(config)# ip http authentication aaa login-authentication local
console(config)# username admin password user1 privilege 15
console(config)# ip http authentication aaa login-authentication local
console(config)# username admin password user1 privilege 15