Reference Guide

486 Quality of Service
Configuring QoS Basic Mode Using CLI Commands
The following is a sample script configuring QoS Basic mode.
QoS Advanced Mode
This section describes QoS Advanced mode.
It contains the following topics:
•Overview
• DSCP Mapping
• Class Mapping
• Aggregate Policer
•Policy Table
•Policy Class Maps
• Policy Binding
Table 22-10. Sample CLI Script to Configure QoS Basic Mode
CLI Command Description
console#configure
console(config)# qos basic
Enable QoS in Basic mode.
console(config)#mac access-list
extended MAC1
Define an ACL named
"MAC1"
console(config-mac-a1)#deny
00:00:00:00:00:11 00:00:00:00:00:ff
any
MAC1 discards all traffic with
source MAC
00:00:00:00:00:XX addresses.
console(config-mac-a1)# permit any
any
MAC1 permits all other
traffic.
console(config-mac-a1)#exit Exit ACL mode.
console(config)#interface gi0/1 Enter Interface mode on port
gi0/1.
console(config-if)#service-acl input
mac1
Bind MAC1 to port gi0/1.