Reference Guide

474 Quality of Service
Setting QoS Mode Using CLI Commands
The following table summarizes the CLI commands for setting the QoS
mode.
The following is an example of the CLI commands:
QoS Properties
To set the default CoS value on incoming, untagged packets:
1
Click Quality of Service > General > QoS Properties in the tree view to
display the
QoS Properties: Summary page.
The default CoS values for all interfaces are displayed.
2 To modify the CoS value for an interface, click Edit , and enter the fields:
–
Interface — Select a port or LAG if required.
–
Set Default CoS — Enter the default CoS tag value for untagged
packets.
Configuring QoS Properties Using CLI Commands
The following table summarizes the CLI commands for configuring fields in
the QoS Properties page.
Table 22-1. QoS Mode CLI Commands
CLI Command Description
qos [basic|advanced]
no qos
Enables QoS on the device.
Use the no form of this command to disable QoS
on the device
show qos Displays the QoS mode.
console(config)# qos basic
Table 22-2. QoS Properties CLI Commands
CLI Command Description
qos cos default-cos
no qos cos
Defines the default CoS value of a port.
Use the no form of this command to restore the
default configuration.