Reference Guide

442 DHCP
To enable DHCP relay on a port, LAG, or VLAN:
1
Click Switching > DHCP Relay > Interface Settings in the tree view to
display the
Interface Settings: Summary page.
The currently-define DHCP interfaces are displayed.
2 To enable DHCP relay on an interface, click Add .
3 Select the interface.
Defining Interface Settings Using CLI Commands
The following table summarizes the CLI commands for defining fields
displayed in the Interface Settings pages.
Interface Settings Parameters CLI Commands
CLI Command Description
ip dhcp relay enable
no ip dhcp relay enable
Enables the DHCP relay features on the
interface (in Interface Configuration
mode).
Use the no form of this command to
disable the DHCP relay agent feature on
the interface.
ip dhcp relay address ip-
address
no ip dhcp relay address
Defines a DHCP servers available for
DHCP relay.
Use the no form of this command to
remove servers from the list.