Reference Guide

424 Dynamic ARP Inspection
Creating a Dynamic ARP Inspection List Using CLI Commands
The following table summarizes the CLI commands for configuring the fields
in the
Dynamic ARP Inspection List pages.
The following is an example of some of the CLI commands:
Dynamic ARP Inspection Entries
To add additional addresses to the lists defined in the Dynamic ARP
Inspection List
page:
1
Click Switching > Dynamic ARP Inspection > Dynamic ARP
Inspection Entries
in the tree view to display the Dynamic ARP
Inspection Entries: Summary
page.
The dynamic ARP entries for the selected list are displayed.
2 To add a new address pair to a list, click Add and select the list.
3 Enter the fields:
•
IP Address — Enter the IP address that will be mapped to the MAC
address entered below.
•
MAC Address — Enter the MAC address that will be mapped to the
IP address entered above.
Table 19-2. Dynamic ARP Inspection List CLI Commands
CLI Command Description
ip arp inspection list
create name
no ip arp inspection list
create name
Creates a static ARP binding list and
enters the ARP list configuration mode.
Use the no form of this command to
delete the list.
console(config)# ip arp inspection list create
servers
console(config-ARP-list)#