Reference Guide

42 Using the CLI
These modes are described below.
User EXEC Mode
During CLI session initialization, the CLI is in User EXEC mode. Only a
limited subset of commands is available in User EXEC mode. This level is
reserved for tasks that do not change the terminal configuration and is used
to access configuration sub-systems.
After logging into the device, User EXEC command mode is enabled. The
user-level prompt consists of the host name followed by the angle bracket
(>). For example: console>
NOTE:
The default host name is console unless it has been modified during
initial configuration.
The User EXEC commands enable connecting to remote devices, changing
terminal settings on a temporary basis, performing basic tests, and listing
system information.
To list the User EXEC commands, enter a question mark at the command
prompt.
To enter the next level, Privileged EXEC mode, a password is required (if
configured).
Privileged EXEC Mode
Privileged EXEC mode provides access to the device global configuration.
Privileged access can be protected, to prevent unauthorized access and to
secure operating parameters. Passwords are displayed on the screen, and are
case-sensitive.
NOTE:
The enable command is only necessary if you login with privilege level less
than 15.
To access and list the Privileged EXEC mode commands:
1
At the prompt type enable and press <Enter> .
2 When a password prompt displays, enter the password and press
<Enter> .