Reference Guide

402 LLDP
The following is an example of the CLI commands:
MED Port Settings
To assign MED network policies to ports:
1
Click Switching > LLDP > MED Port Settings in the tree view to display
the
MED Port Settings: Summary page.
2 All ports are displayed along with the following fields:
–
LLDP MED Status — Specifies if LLDP-MED is enabled on the
selected port.
–
Network Policy — Specifies whether a network policy is assigned to
the port.
–
Location — Specifies whether the location is advertised.
–
PoE — Specifies whether PoE is enabled on the port
3 To modify network policies on a port, click Edit .
4 Select the port to be configured, and enter the fields for the port:
–
Enable LLDP-MED — Enable/disable LLDP-MED on the port.
–
Available TLVs — Contains a list of available TLVs that can be
advertised by the port. The possible options are:
•
Network Policy — Advertises the network policy attached to the
port.
•
Location — Advertises the port’s location.
Move the TLVs to be published to the
Tx Optional TLV s list.
–
Available Network Policy — Contains a list of network policies that
can be assigned to a port. Move the network policies to be assigned to
the port to the
Network Policy list.
–
Location Coordinate (16 Bytes in Hex) — Displays the device’s
location map coordinates.
–
Location Civic Address (6-160 Bytes in Hex) — Displays the device’s
civic or street address location, for example 414 23rd Ave E.
console(config)# lldp med network-policy 1 voice-
signaling vlan 1