Reference Guide

398 LLDP
The following is an example of the CLI commands:
LLDP Port Settings
LLDP configuration of a port includes activating LLDP notification on it,
and selecting the optional TLVs that will be sent in the LLDP PDU, in
addition to the mandatory ones.
By setting these properties, it is possible to provide additional types of
information to those network devices that support the LLDP.
To configure LLDP per port:
1
Click Switching > LLDP > LLDP Port Settings in the tree view to
display the
LLDP Port Settings: Summary page.
LLDP settings for all ports are displayed.
2 To modify the LLDP settings for a port, click Edit and select the port to be
configured.
3 Select the transmission type on which LLDP is to be configured in the
State field. The possible options are:
–
Tx Only — Enables LLDP on transmitting LLDP packets only.
– Rx Only — Enables LLDP on receiving LLDP packets only.
lldp tx-delay seconds
no lldp tx-delay
Specifies the delay between successive
LLDP frame transmissions.
Use the no form of this command to
restore the default configuration.
console(config)# interface vlan 1
console(config-if)# lldp run
console(config)# lldp timer 30
console(config)# lldp hold-multiplier 3
console(config)# lldp reinit 4
Table 17-1. LLDP Properties CLI Commands (continued)
CLI Command Description