Reference Guide

Multicast Support 391
Configuring Unregistered Multicast Using CLI Commands
The following table summarizes the CLI commands for configuring
unregistered Multicast on the device:
The following is an example of the CLI commands:
Multicast TV VLAN
This section describes the Multicast TV VLAN feature.
It contains the following sections:
• Multicast TV VLAN Overview
• Multicast TV VLAN Membership
• Multicast TV VLAN Mapping
Table 16-7. Unregistered Multicast CLI Commands
CLI Command Description
bridge multicast unregistered
{forwarding | filtering}
no bridge multicast unregistered
Configures the forwarding state of
unregistered Multicast addresses on a
port or LAG. Before using this com-
mand, enter the Interface Configura-
tion mode as shown in the example.
Use the no format of the command to
restore the default configuration.
show bridge multicast unregistered
[interface-id]
Displays the unregistered multicast
filtering configuration.
console(config)# interface gi0/1
console(config-if)# bridge multicast unregistered filtering
console # show bridge multicast unregistered
Port Unregistered
------- --------
gi0/1 Forward
gi0/2 Filter
gi0/3 Filter