Reference Guide

Initial Configuration of the Switch 39
NOTE: CLI and/or GUI need only be used if the default configuration is not
sufficient.
The switch can be configured in the following modes from the GUI:
• Basic — Elementary network configuration for the switch.
•
Advanced — Full network configuration mode that enables configuration
of all switch capabilities. This mode is intended for advanced network
administrators.
Default IP Address DHCP enabled by default; If DHCP is disabled,
the default IP address of 192.168.2.1 over the
OOB interface is used.
Default system mode (for
VRTX 1Gb only)
Layer 2
Table 4-1. Major System Defaults
Feature Defaults