Reference Guide

374 Multicast Support
The following is an example of the CLI commands:
Bridge Multicast Groups
The Bridge Multicast Group: Summary page displays the ports and LAGs
attached to a Multicast service group and the manner in which the port or
LAG joined it.
To add and configure a Multicast group:
1
Click Switching > Multicast Support > Bridge Multicast Group in the
tree view to display the
Bridge Multicast Group: Summary page.
The ports and LAGs in the selected Multicast Group are displayed.
2 Select a VLAN and enter the Multicast group IP address in Bridge
Multicast Address
.
Two rows of ports and LAGs are displayed:
–
Static — Displays available static ports/LAGs. These port/LAGs can
be included or excluded from the Multicast groups, as described
below.
–
Current — Displays status of ports/LAGs in the Multicast group, as
actually applied.
3 For each port in the VLAN, toggle to S to join the port to the selected
Multicast group as a static port. Toggle a port to
F to indicate that it is
Forbidden to this group. Leave the field empty if it is not involved in the
VLAN.
4 To add a new Multicast group, click Add , and enter the fields:
–
IP Format — Select whether this is an IPv4 or IPv6 group.
–
VLAN ID — Select the VLAN ID to set its forwarding method.
–
New Bridge IP Multicast — Enter a Multicast group IP address.
–
New Bridge MAC Multicast — Enter a Multicast group MAC
address.
console(config)# bridge multicast filtering
console(config)# ip igmp snooping
console(config) ipv6 mld snooping