Reference Guide

Multicast Support 373
Enabling Multicast Filtering and IGMP Snooping Using CLI Commands
The following table summarizes the CLI commands for enabling Multicast
Filtering and IGMP snooping as displayed on the Global Parameters page.
Table 16-1. Multicast Filtering and Snooping CLI Commands
CLI Command Description
bridge multicast filtering
no bridge multicast filtering
Enables filtering of Multicast addresses.
Use the no form of this command to
disable Multicast address filtering.
ip igmp snooping
no ip igmp snooping
Enables IGMP Snooping.
Use the no form of this command to
disable IGMP Snooping.
ip igmp snooping vlan vlan-id
querier version {2 | 3}
no ip igmp snooping vlan
vlan-id querier version
Configures the IGMP version of an IGMP
Snooping querier on a specific VLAN.
Use the no form of this command to
disable IGMP Snooping.
ipv6 mld snooping querier
no ipv6 mld snooping querier
Enables MLD Snooping querier.
Use the no form of this command to
disable IGMP Snooping querier.
ipv6 mld snooping
no ipv6 mld snooping
Enables MLD Snooping.
Use the no form of this command to
disable MLD Snooping.
ipv6 mld snooping vlan vlan-
id
no ipv6 mld snooping vlan
vlan-id
Enables MLD Snooping on a specific
VLAN.
Use the no form of this command to
disable MLD Snooping on a specific
VLAN.
bridge multicast mode {mac-
group | ip-group | ip-src-
group}
no bridge multicast mode
Configures the Multicast bridging mode.
Use the no form of this command to
return to the default configuration