Reference Guide

Link Aggregation 365
3 To modify LACP parameters for a particular port, click Edit , and enter the
following fields:
–
Select a Port — Select the port for which timeout and priority values
are assigned.
–
LACP Port Priority (1-65535) — Enter the LACP priority value for
the port.
–
LACP Timeout — Select the rate of periodic transmissions of LACP
PDUs. The possible options are:
•
Long — Slow transmission rate
•
Short — Fast transmission rate
Configuring LACP Parameters Using CLI Commands
The following table summarizes the CLI commands for configuring LACP
parameters as displayed in the LACP Parameters page.
Table 15-1. LACP Parameters CLI Commands
CLI Command Description
lacp system-priority value
no lacp system-priority
Configures the system priority.
Use the no form of this command to
restore the default configuration.
lacp port-priority value
no lacp port-priority
Configures the priority value for
physical ports.
Use the no form of this command to
restore the default configuration.
lacp timeout
{long | short}
no lacp timeout
Assigns an administrative LACP
timeout.
Use the no form of this command to
restore the default configuration.
show lacp interface-id
[parameters | statistics |
protocol-state]
Displays LACP information for
ethernet ports.