Reference Guide

358 VLANs
– Class of Service — Select to add a CoS level to untagged packets,
received on the voice VLAN. The possible values are 0 to 7, where 7 is
the highest priority. 0 is used as a best-effort, and is invoked
automatically when no other value has been set.
–
Remark CoS — Select Enable to use the Remark CoS feature.
–
Voice VLAN Aging Time — Enter the interval of time after which the
port exits the voice VLAN, if no voice packets are received.
The aging time starts after the MAC address is aged out from the
Dynamic MAC Address table. The default time is 300 sec. For more
information on defining MAC address age out time, see Dynamic
Address Table.
Defining Voice VLAN Properties Using CLI Commands
The following table summarizes the CLI command for defining voice VLAN
properties
.
Table 14-7. Voice VLAN Properties CLI Commands
CLI Command Description
voice vlan state{oui-enabled
| disabled]
no voice vlan state
Sets the type of voice VLAN that is
functional on the device.
Use the no form of this command to
disable voice VLAN entirely.
voice vlan id vlan-id
no voice vlan id
Enables the voice VLAN and configures
the voice VLAN ID in Global
Configuration mode.
Use the no form of this command to
disable voice VLAN.
voice vlan cos cos [remark]
no voice vlan cos
Sets the voice VLAN Class of Service
(CoS) queue.
Use the no form of this command to
restore the default configuration.
voice vlan aging-timeout
minutes
no voice aging-timeout
Sets the voice VLAN aging timeout in
Global Configuration mode.
Use the no form of this command to
return to default.