Reference Guide

290 Ports
DELL CONFIDENTIAL – PRELIMINARY 3/6/14 - FOR PROOF ONLY
The following is an example of the CLI commands:
LAG Configuration
Use the LAG Configuration pages to configure LAGs. The device supports
up to 12 LAGs per system. For information about Link Aggregated Groups
(LAGs) and assigning ports to LAGs, see
Link Aggregation .
To configure LAGs:
1
Click Switching > Ports > LAG Configuration in the tree view to display
the
LAG Configuration: Summary page.
The LAG parameters are displayed.
2 To configure a LAG, click Edit .
3 Select the LAG and enter the fields:
–
LAG Mode — Select the LAG mode. The possible options are:
•
Static — The ports comprise a single logical port for high-speed
connections between networking devices.
console(config)# interface gi2/1
console(config-if)# description "RD SW#3"
console(config-if)# shutdown
console(config-if)# no shutdown
console(config-if)# speed 100
console(config-if)# duplex full
console(config-if)# negotiation
console(config-if)# back-pressure
console(config-if)# flowcontrol on
console(config-if)# mdix auto
console(config-if)# end
console# show interfaces configuration gi2/1
Flow Admin Back Mdix
Port Type Duplex Speed Neg control State Pressure Mode
-------- ------------ ------ ----- -------- ------- ----- -------- ----
gi2/1 1G-Copper Full 1000 Enabled Off Up Disabled Auto
console# show interfaces status gi2/1
Flow Link Back Mdix
Port Type Duplex Speed Neg ctrl State Pressure Mode
-------- ------------ ------ ----- -------- ---- ----------- -------- ----
gi2/1 1G-Copper -- -- -- -- Down -- --