Reference Guide

288 Ports
DELL CONFIDENTIAL – PRELIMINARY 3/6/14 - FOR PROOF ONLY
Configuring Ports Using CLI Commands
The following table summarizes the CLI commands for configuring ports as
displayed in the Port Configuration pages.
Table 10-8. Port Configuration CLI Commands
CLI Command Description
eee enable
no eee enable
Enables the EEE mode globally.
Use the no format of the command
to disable the mode.
eee lldp enable
no eee lldp enable
Enables EEE support by LLDP on
an Ethernet port.
Use the no format of the command
to disable the support.
description string
no description
Adds a description to an interface
configuration.
Use the no form of this command to
remove the description.
shutdown
no shutdown
Disables an interfaces.
Use the no form of this command to
restart a disabled interface.
set interface active
{interface-
id
}
Reactivates an interface that is
shutdown.
speed {10|100|1000|}
no speed
Configures the speed of a given
Ethernet interface when not using
auto negotiation.
Use the no form of this command to
restore the default configuration.
duplex {half|full}
no duplex
Configures the full/half duplex
operation of a given Ethernet
interface when not using auto
negotiation.
negotiation [capability
[capability2…capability5]
no negotiation
Enables auto negotiation operation
for the speed and duplex parameters
of a given interface.
Use the no form of this command to
disable auto-negotiation.