Reference Guide

274 Ports
Jumbo Frames
Jumbo frames are frames of up to 10 Kb in size. If Jumbo frames are not
enabled, the system supports a packet size of up to 1,632 bytes.
To enable jumbo frames:
1
Click Switching > Ports > Jumbo Frames in the tree view to display the
Jumbo Frames page.
The current jumbo frames setting is displayed.
2 Enable/disable jumbo frames in the New Setting (after reset) field.
NOTE: You must save the configuration and reboot the device in order to make
jumbo frames operational.
Configuring Jumbo Frames Using CLI Commands
The following table summarizes the CLI commands for configuring Jumbo
frames.
The following is an example of the CLI commands:
Port tagging No tagging
Flow Control On
Back Pressure Off
Table 10-2. Jumbo Frames CLI Commands
CLI Command Description
port jumbo-frame
no port jumbo-frame
Enables jumbo frames on the device.
Use the no form of this command to disable
jumbo frames.
console(config)# port jumbo-frame
Table 10-1. Port Default Settings
(continued)
Function Default Setting