Reference Guide

248 Network Security
Configuring ACL Bindings Using CLI Commands
The following table summarizes the CLI commands for configuring ACL
Bindings.
.
The following is an example of some of the CLI commands:
Proprietary Protocol Filtering
Protocol filters are used to disallow receiving specific proprietary protocol
packets through an interface. These can be enabled for specific ports.
If a protocol filter is enabled on a port, you cannot enable a QoS ACL on this
port.
To configure Proprietary Protocol Filtering:
1
Click Switching > Network Security > Proprietary Protocol Filtering to
display the
Proprietary Protocol Filtering: Summary page.
A list of the ports and their filtered protocols is displayed.
2 Click Edit to modify the filtered protocols for a specific port.
3 Select an interface.
Table 9-8. ACL Bindings CLI Commands
CLI Command Description
service-acl input acl-name1
[acl-name2] default-action
[deny-any | permit-any]
no service-acl input
Controls access to an interface
Use the no form of the command to
remove access control.
show access-lists [acl-name] Displays access control lists (ACLs)
configured on the switch.
console(config)# mac access-list extended server
console(config-mac-al)# permit 00:00:00:00:00:01
00:00:00:00:00:ff any
console(config-mac-al)# exit
console(config)# interface gi/0/1
console(config-if)# service-acl input server