Reference Guide

230 Network Security
The following is an example of the CLI commands:
ACLs
This section describes Access Control Lists (ACLs), which enable defining
classification actions and rules for specific ingress or egress ports.
It contains the following topics:
• ACL Overview
• MAC-Based ACLs
• MAC-Based ACEs
•IPv4-Based ACLs
•IPv4-Based ACEs
•IPv6-Based ACLs
•IPv6-Based ACEs
port security
[forward|discard|discard-shutdown]
[trap seconds]
no port security
Configures port security on an
interface.
Use the no form of this command
to disable port security.
show ports security
[interface-id | detailed]]
Displays lock status of specified
interface or of all interfaces.
console # show ports security
Port Status Learning Action Maximum Trap Frequency
------- -------- -------- -------- ------- ---- ---------
gi0/1 Disabled Max-Addresses - 10 - -
gi0/2 Disabled Lock - 1 - -
gi0/3 Disabled Lock - 1 - -
gi0/4 Disabled Lock - 1 - -
gi0/5 Disabled Lock - 1 - -
gi0/6 Disabled Lock - 1 - -
gi0/7 Disabled Lock - 1 - -
gi0/8 Disabled Lock - 1 - -
Table 9-1. Port Security CLI Commands (continued)
CLI Command Description