Reference Guide

222 IP Addressing
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Sets the “managed address
configuration flag” in IPv6 router
advertisements.
Use the no form to clear the flag.
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
Configures the interval between
IPv6 neighbor solicitation
retransmissions on an interface.
Use the no form of this command
to return to the default value.
ipv6 nd prefix {ipv6-prefix/prefix-
length | default} [no-advertise |
{[valid-lifetime preferred-
lifetime]
[no-autoconfig] [off-link | no-
onlink]}]
no ipv6 nd prefix [ipv6-
prefix/prefix-length | default]
Configures which IPv6 prefixes are
included in IPv6 Neighbor
Discovery (ND) router
advertisements.
Use the no form of this command
to return to the default value.
ipv6 nd ra lifetime seconds
no ipv6 ra lifetime
Configures the Router Lifetime
value in IPv6 router
advertisements on an interface
Use the no form of this command
to return to the default value.
ipv6 nd ra suppress
no ipv6 ra suppress
Suppresses IPv6 router
advertisement transmissions on an
interface.
Use the no form of this command
to return to the default value.
ipv6 nd reachable-time milliseconds
no ipv6 nd reachable-time
Configures the amount of time
that a remote IPv6 node is
considered reachable after some
reachability confirmation event has
occurred.
Use the no form of this command
to return to the default value.
Table 8-22. Router Advertisements CLI Commands
(continued)
CLI Command Description