Reference Guide

IP Addressing 219
The following is an example of the CLI commands:
IPv6 Router
NOTE: This feature is supported in R1-2210 only.
This section describe how to configure the device as an IPv6 router. It
contains the following topics:
• Router Advertisement
• IPv6 Prefixes
Router Advertisement
IPv6 routers are able to advertise their prefixes to neighboring devices. This
feature can be enabled or suppressed per interface, as follows:
1
Click System > IPv6 Addressing > IPv6 Router > Router
Advertisement .
2 To configure an interface listed in the Router Advertisement Table, select
it and click
Edit .
3 Enter the following fields:
–
Suppress Router Advertisement —Select Yes to suppress IPv6 router
advertisement transmissions on the interface. If this feature is not
suppressed, enter the following fields.
–
Router Preference —Select either Low, Medium or High preference
for the router. Router advertisement messages are sent with the
preference configured in this field. If no preference is configured, they
are sent with a medium preference.
console# config
console(config)# ipv6 neighbor 3000::a31b vlan 1
001b.3f9c.84ea
console# show ipv6 neighbors dynamic
Interface IPv6 Address HW Address State Router
--------- ------------ ---------- ----- -----
VLAN 1 3000::a31b 0001b.3f9c.84ea Reachable Yes