Reference Guide

212 IP Addressing
– Metric — (for R1-2210)Cost of this hop.
2 To add an IPv6 default gateway, click Add, and enter the fields:
–
IPv6 Address Type — Displays that the IP address was added to the
interface through a link local address.
–
Link Local Interface — Displays the outgoing interface through
which the default gateway can be reached.
–
Default Gateway IPv6 Address — Enter the Link Local IPv6 address
of the default gateway.
–
Metric (For R1-2210)— Enter the cost of this hop.
NOTE: When defining a default gateway interface, ensure that the interface is in
Layer 3 mode. This can be done via the radio button in Switching > VLAN > Port
Setting.
Defining IPv6 Default Gateway Parameters Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the IPv6 Default Gateway pages.
Table 8-18. IPv6 Default Gateway CLI Commands
CLI Command Description
ipv6 default-gateway ipv6-
address
no ipv6 default-gateway
Defines an IPv6 default gateway.
Use the no form of this command to remove
the default gateway.
show ipv6 route Displays the current state of the IPv6 routing
table.