Reference Guide

IP Addressing 201
IPv6 Addressing
This section describes the following sections:
• IPv6 Global Parameters
•IPv6 Interface
• IPv6 Routes Table
• IPv6 Default Gateway
• ISATAP Tunnel
• IPv6 Neighbors
•IPv6 Router
IPv6 Global Parameters
To define IPv6 global parameters:
Click System > IPv6 Addressing > IPv6 Global Parameters.
Enter values for the following fields:
• IPv6 Routing (for R1-2210) —Select to enable IPv6 routing. If this is not
enabled, the device acts as a host (not a router) and can receive
management packets, but cannot forward packets. If routing is enabled,
the device can forward the IPv6 packets.
•
ICMP Error Rate Limit Interval (0-2147483647) — Enter how often the
ICMPv6 error messages are generated in milliseconds. The value of this
parameter together with the Bucket Size parameter (below) determines
how many ICMP error messages may be sent per time interval, for
example, a rate-limit interval of 100 ms and a bucket size of 10 messages
translates to 100 ICMP error messages per second.
•
ICMP Error Rate Limit Bucket Size (1-200) — Enter the maximum
number of ICMP error messages that can be sent by the device per
interval. The value of this parameter together with the
ICMP Error Rate
Limit Interval
parameter determines how many ICMP error messages may
be sent per time interval, for example, a rate-limit interval of 100 ms and a
bucket size of 10 messages translates to 100 ICMP error messages per
second.