Reference Guide

178 Configuring System Information
The following is an example of the CLI commands:
sFlow Interface Settings
To sample datagrams or counters from a port, the port must be associated
with a receiver. sFlow port settings can be configured only after a receiver has
been defined in the sFlow Receiver Settings pages.
To enable sampling and configure the port from which to collect the sFlow
information:
1
Click System > sFlow > sFlow Interface Settings in the tree view to
display the
sFlow Interface Settings: Summary page.
The sflow interface settings are displayed.
2 To associate an sFlow receiver with a port, click Add , and enter the fields:
–
Interface — Select the unit/port from which information is collected.
console(config)# sflow receiver 2 1.1.1.1 port 6343
console# show sflow configuration
Receivers
Index IP Address Port Max Datagram Size
----- -------------------- -------- ----------------
1 0.0.0.0 6343 1400
2 172.16.1.2 6343 1400
3 0.0.0.0 6343 1400
4 0.0.0.0 6343 1400
5 0.0.0.0 6343 1400
6 0.0.0.0 6343 1400
7 0.0.0.0 6343 1400
8 0.0.0.0 6343 1400
Interfaces
Interface Flow Counters Max Header Collector Index
Sampling Sampling Interval Size Sampling Counters
--------- --------- ----------------- ------------ ----------- ---------
te0/1 1/2048 60 sec 128 1 1
te0/2 1/4096 Disabled 12
8 0 2