Reference Guide

Configuring System Information 177
– IP Address — Enter the receiver’s IP address.
4 Enter the fields:
–
UDP Port — Port to which SYSLOG message are sent.
–
Maximum Datagram Size (Bytes) — Maximum number of bytes that
can be sent to the receiver in a single sample datagram (frame).
Adding an sFlow Receiver Using the CLI Commands
The following table summarizes the CLI commands for adding an sFlow
receiver.
Table 7-48. sflow Receiver CLI Commands
CLI Command Description
sflow receiver index {ipv4-
address|ipv6-address|hostname}
[port port] [max-datagram-size
bytes]
no sflow receiver index
Defines an sFlow receiver.
Use the no form of this command to
remove the definition of the receiver.
show sflow configuration
[port_id]
Displays the sFlow configuration for
ports that are enabled for Flow
sampling or Counters sampling.