Reference Guide

Configuring System Information 171
DELL CONFIDENTIAL – PRELIMINARY 3/6/14 - FOR PROOF ONLY
To select the image file to be used after reset:
1
Click System > File Management > Active Images in the tree view to
display the
Active Images page.
The following fields are displayed:
–
Active Image — The version of the image file that is currently active
on the device.
–
After Reset — Select one of the possible versions of the image to be
active after reset.
2 Click Apply to select the image file to be used after reset in After Reset .
Working with the Active Image File Using CLI Commands
The following table summarizes the CLI commands for viewing fields
displayed in the Active Images
.
The following is an example of the CLI commands:
Copy Files
Use the Copy Files page to perform the following:
• Copy the firmware on the device to another, specified file.
• Copy the master Running Configuration file to the Startup Configuration
file, or vice versa.
• Copy the master Startup Configuration file to a backup file on the Flash
file system.
Table 7-45. Active Image CLI Commands
CLI Command Description
boot system {image-1
| image-2}
Sets the system image that the device loads at
startup.
show version [md5] Displays version information for the system
console# boot system image-1 all