Reference Guide

170 Configuring System Information
– Destination File Name (1-64 Characters) — The configuration file
name/path to which the file is uploaded.
–
Transfer File Name — The configuration file that is uploaded. The
possible options are:
•
Running Configuration — Uploads the Running Configuration
file.
•
Startup Configuration — Uploads the Startup Configuration file.
10 Click Activate to start the upload process.
Uploading Files Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the File Upload page.
The following is an example of the CLI commands:
Active Images
There are two firmware images, Image1 and Image2, stored on the switch.
One of these images is identified as the active image, and the other is
identified as the inactive image. The switch boots from the active image.
You can switch the inactive image to the active image, and then reboot the
switch.
Table 7-44. File Upload CLI Commands
CLI Command Description
copy source-url destination-url Copies any file from a source to a
destination.
console# copy image tftp://10.6.6.64/uploaded.ros
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Copy: 4234656 bytes copied in 00:00:33 [hh:mm:ss]
01-Jan-2000 07:30:42 %COPY-W-TRAP:
The copy operation was completed successfully