Reference Guide

168 Configuring System Information
Downloading Files Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the File Download page.
The following is an example of the CLI command:
NOTE:
Each exclamation mark (!) indicates that ten packets were successfully
transferred.
File Upload
Software and configuration files can be uploaded to an external device using
HTTP or TFTP.
To upload a configuration file:
1
Click System > File Management > File Upload in the tree view to
display the
File Upload page.
2 Enter the IP Format fields for the server IP address.
–
Supported IP Format — Select whether IPv4 or IPv6 format is
supported.
–
IPv6 Address Type — When the server supports IPv6, this specifies
the type of static address supported. The possible options are:
•
Link Local — A Link Local address that is non-routable and used
for communication on the same network only.
Table 7-43. File Download CLI Commands
CLI Command Description
copy source-url destination-
url
Copies files from a source to a
destination.
console# copy tftp://10.6.6.64/pp.txt startup-config
....!
Copy: 575 bytes copied in 00:00:06 [hh:mm:ss]
01-Jan-2000 06:41:55 %COPY-W-TRAP:
The copy operation was completed successfully