Reference Guide

130 Configuring System Information
NOTE: The Auto option, which is the default option for the Source IPv4 and Source
IPv6 fields, causes the system to take the source IP address from the IP address
defined on the outgoing interface.
3 To add a TACACS+ server, click Add , and enter the fields on the page.
The fields below are those that were not described on the
TACACS+:
Summary
page.
–
Supported IP Format — Select whether the IPv4 or IPv6 format is
supported for the TACACS+ server IP address.
–
IPv6 Address Type — Select whether the Link-Local or Global format
of the
IPv6 Address is supported for the TACACS+ server IP address.
–
Link Local Interface — Select whether the link local address is the
default VLAN or an ISATAP tunnel.
–
Host IP Address — Enter the TACACS+ server IP address.
–
Priority (0-65535) — Enter the order in which the TACACS+ servers
are used if several are defined.
– Key String (0-128 Characters) — Enter the key of the TACACS+
server.
–
Authentication Port (0-65535) — Enter the port number through
which the TACACS+ session occurs.
–
Timeout for Reply (1-30) — Enter the amount of time that passes
before the connection between the device and the TACACS+ server
times out.
–
Single Connection — Check to maintain a single open connection
between the device and the TACACS+ server.
Wherever available, check
Use Default to use a value that was entered in
the
TACACS+: Summary page.