Reference Guide

UDLD Commands 849
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC3_latest\UDLD.fm
DELL CONFIDENTIAL – PRELIMINARY 5/21/14 - FOR PROOF ONLY
Command Mode
Global Configuration mode
User Guidelines
Use this command to change the default value of the message interval - the
interval between two sequential sent probe messages.
Example
This example shows how to globally set the interval to 40sec:
console(config)# udld message timeout 40
udld port
To enable the UDLD protocol on an Ethernet port, use the udld port
command in Interface Configuration mode. To return to the default, use the
no form of this command.
Syntax
udld port [aggressive | normal | disable]
no udld port
Parameters
• aggressive —Enables UDLD in aggressive mode on this interface.
•
normal —Enables UDLD in normal mode on this interface. The normal
keyword is applied if no keyword is specified.
•
disable —Disables UDLD on this interface.
Default Configuration
The defaults are as follows:
• Fiber interfaces are in the state configured by the udld command.
• Non-fiber interfaces are in the Disable state.
Command Mode
Interface (Ethernet) Configuration mode