Reference Guide

IPv6 Tunnel Commands 745
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC3_latest\Tunnel New Edition.fm
DELL CONFIDENTIAL – PRELIMINARY 5/21/14 - FOR PROOF ONLY
When the tunnel local IPv4 address is changed the IPv6 interface on the
tunnel is re-enabled that causes removing static IPv6 configuration on the
tunnel (for example, global IPv6 addresses, static IPv6 routes via the tunnel,
etc.).
Example
console(config)# interface tunnel 1
console(config-if)#
tunnel source 120.12.3.4
console(config-if)# exit
show ipv6 tunnel
Use the show ipv6 tunnel EXEC mode command to display information on
the ISATAP tunnel.
Syntax
show ipv6 tunnel [all]
Parameters
• all —The switch displays all parameters of the tunnel. If the keyword is not
configured only the tunnel parameters corresponding to its type are
displayed.
Command Mode
User EXEC mode
Example
Example 1. The following example displays information on the ISATAP
tunnel, when the all keyword is not configured:
console# show ipv6 tunnel
Tunnel 2
Tunnel type : ISATAP
Tunnel status : UP
Tunnel Local address type : auto