Reference Guide

730 IPv6 Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC3_latest\IPv6_Router.fm
DELL CONFIDENTIAL – PRELIMINARY 5/21/14 - FOR PROOF ONLY
prefix 2011::1/64
valid-lifetime 3,600 secs
preferred-lifetime 2,700 secs
off-link
auto-config
show ipv6 neighbors
Use the show ipv6 neighbors command in User EXEC or Privileged EXEC
mode to display IPv6 neighbor discovery (ND) cache information.
Syntax
show ipv6 neighbors [ interface-id | ipv6-address | ipv6-hostname ]
Parameters
• interface-id —Specifies the identifier of the interface from which IPv6
neighbor information is to be displayed.
•
ipv6-address —Specifies the IPv6 address of the neighbor. This argument
must be in the form documented in RFC4293 where the address is
specified in hexadecimal using 16-bit values between colons.
•
ipv6-hostname —Specifies the IPv6 host name of the remote networking
device.
Default Configuration
All IPv6 ND cache entries are listed.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
When the interface-id argument is not specified, cache information for all
IPv6 neighbors is displayed. Specifying the
interface-id argument displays
only cache information about the specified interface.