Reference Guide

472 LLDP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC3_latest\LLDP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/21/14 - FOR PROOF ONLY
• tlv —Specifies the TLV that should be included. Available TLVs are:
Network-Policy, Location, Inventory. The Capabilities TLV is always
included if LLDP-MED is enabled.
•
disable —Disable LLDP MED on the port
Default Configuration
Enabled with network-policy TLV
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables LLDP MED with the location TLV on te0/3.
console(config)# interface te0/3
console(config-if)#
lldp med enable location
lldp med notifications topology-change
Use the lldp med notifications topology-change Interface (Ethernet)
Configuration mode command to enable sending LLDP MED topology
change notifications on a port. Use the no form of this command to restore
the default configuration.
Syntax
lldp med notifications topology-change {enable | disable}
no lldp med notifications topology-change
Parameters
• enable —Enables sending LLDP MED topology change notifications.
•
disable —Disables sending LLDP MED topology change notifications.
Default Configuration
Disable is the default.