Reference Guide

Address Table Commands 435
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC3_latest\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 5/21/14 - FOR PROOF ONLY
User Guidelines
The default port mode is called regular. In this mode, the port allows
unlimited learning of dynamic addresses.
The static MAC addresses may be added on the port manually by the mac
address-table static command.
The command may be used only when the interface in the regular (non-
secure with unlimited MAC learning) mode.
Use the port security mode command to change the default mode before the
port security command.
Example
The following example sets the port security mode to
Lock for te0/4.
console(config)# interface te0/4
console(config-if)# port security mode lock
console(config-if)# port security
console(config-if)# exit
port security max
Use the port security max Interface (Ethernet, Port Channel) Configuration
mode command to configure the maximum number of addresses that can be
learned on the port while the port is in port, max-addresses or secure mode.
Use the no form of this command to restore the default configuration.
Syntax
port security max max-addr
no port security max
Parameters
max-addr—Specifies the maximum number of addresses that can be learned
on the port. (Range: 0–256)