Reference Guide

Address Table Commands 423
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC3_latest\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 5/21/14 - FOR PROOF ONLY
Syntax
bridge multicast ipv6 source ipv6-source-address group ipv6-multicast-
address [[add | remove] {ethernet interface-list | port-channel port-channel-
list}]
no bridge multicast ipv6 source ipv6-address group ipv6-multicast-address
Parameters
• ipv6-source-address —Specifies the source IPv6 address.
•
ipv6-multicast-address —Specifies the group IPv6 Multicast address.
•
add —Adds ports to the group for the specific source IPv6 address.
•
remove —Removes ports from the group for the specific source IPv6
address.
•
ethernet interface-list —Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel port-channel-list —Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
Example
The following example registers a source IPv6 address - Multicast IPv6
address pair to the bridge table:
console(config)# interface vlan 8
console(config-if)# bridge multicast source 2001:0:0:0:4:4:4
group FF00:0:0:0:4:4:4:1