Reference Guide

172 SNMP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC3_latest\SNMP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/21/14 - FOR PROOF ONLY
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the source interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to send an SNMP trap or inform.
Use the no snmp-server source-interface traps command to remove the
source interface for SNMP traps.
Use the no snmp-server source-interface informs command to remove the
source interface for SNMP informs.
Use the no snmp-server source-interface command to remove the source
interface for SNMP traps and informs.
Example
The following example configures the VLAN 10 as the source interface for
traps.
console(config)# snmp-server source-interface traps vlan 100
snmp-server source-interface-ipv6
To specify the interface from which a Simple Network Management Protocol
(SNMP) trap originates the informs or traps, use the snmp-server source-
interface command in Global Configuration mode. To returned to the
default, use the no form of this command.
Syntax
snmp-server source-interface-ipv6 {traps | informs} interface-id
no snmp-server source-interface-ipv6 [traps | informs]
Parameters
• traps —Specifies the SNMP traps interface.
•
informs —Specifies the SNMP traps informs.
•
interface-id —Specifies the source interface.