Users Guide

NOTE: If Non-RAID virtual disks are used (and appear in the Virtual Disks list), the Swap Two Virtual Disks option is

enabled only if the system contains a RAID Capable physical disk.

2. Select Continue to Boot and press <Enter>.

Creating the device driver media for Windows driver

installation

Downloading drivers for PERC S130 from the Dell support website

for all operating systems

1. Go to dell.com/drivers.

2. In the Product Selection section, enter the service tag of your system in the Service Tag or Express Service Code field.

NOTE: If you do not have the service tag, select Automatically detect my Service Tag for me to allow the system to

automatically detect your service tag, or select Choose from a list of all Dell products to select your product from

the Product Selection page.

3. Select the Operating System, Category, Release Date, and Importance from the respective drop-down lists.

The drivers that are applicable to your selection are displayed.

4. Download the drivers that you require to a USB drive, CD, or DVD.

5. During the operating system installation, use the media that you created with the Load Driver option to load mass storage

drivers. For more information on reinstalling the operating system, see the operating system document at dell.com/

operatingsystemmanuals.

Downloading drivers from the Dell Systems Service and Diagnostic

Tools media for Windows

1. Insert the Dell Systems Service and Diagnostics Tools media in a system.

The Welcome to Dell Service and Diagnostic Utilities screen is displayed.

2. Select your system model and operating system.

For the list of supported operating systems, see Supported operating systems on page 8.

3. Click Continue.

4. From the list of drivers displayed, select the driver you require.

5. Select the self-extracting zip file and click Run.

6. Copy the driver to a CD, DVD, or USB drive.

Repeat this step for all the drivers you require.

7. During the operating system installation, use the media that you created with the Load Driver option to load mass storage

drivers.

For more information on reinstalling the operating system, see the relevant section for your operating system.

Installing the driver for Windows Server 2008 R2 or

Windows Server 2012/2012 R2

1. Power on the system and boot to the Microsoft Windows Server CD.

2. Follow the instructions on the screen until you reach the Where do you want to install Windows? screen.

3. Insert the CD-ROM, DVD or USB flash drive that contains the driver files.

4. In the Load Driver sub-screen, click Browse.

5. Select the directory that has the controller driver files and click OK.

Installing the drivers