Users Guide

Table Of Contents
2. Click Main Menu > Controller Management > Advanced Controller Management.
3. Click Clear Controller Events.
A screen is displayed indicating that the operation is completed successfully.
4. Click Ok.
Saving controller events
1. Enter the Dell PERC 10 Configuration Utility. See Navigating to Dell PERC 10 configuration utility.
2. Click Main Menu > Controller Management > Advanced Controller Management.
3. Click Save Controller Events.
A screen is displayed indicating that the operation is completed successfully.
4. Click Ok.
Saving debug log
1. Enter the Dell PERC 10 Configuration Utility. See Navigating to Dell PERC 10 configuration utility.
2. Click Main Menu > Controller Management > Advanced Controller Management.
3. Click Save Debug Log.
A screen is displayed indicating that the operation is completed successfully.
4. Click Ok.
Managing link speed
1. Enter the Dell PERC 10 Configuration Utility. See Navigating to Dell PERC 10 configuration utility.
2. Click Main Menu > Controller Management > Advanced Controller Management.
3. Click Manage Link Speed.
You can view/change the physical disk settings for the controller, if required. The possible options are:
Auto
3 Gbps
6 Gbps
12 Gbps
4. Click Ok to save the changes.
NOTE: To reflect the changes, perform an AC power cycle that is disconnecting and reconnecting the power source.
Restoring factory default settings
1. Enter the Dell PERC 10 Configuration Utility. See Navigating to Dell PERC 10 configuration utility.
2. Click Main Menu > Set Factory Defaults.
A screen is displayed asking you to confirm the operation.
3. Select Confirm and click Yes to continue.
Manage controller mode
NOTE:
All existing configurations on the controller must be deleted before proceeding with a controller mode change. Once
the mode transition operation is confirmed, the process can take up to 5 seconds to complete; do not power off or reset
the system until the mode transition operation is complete. This action is not supported on PERC H345 controller.
1. Enter the Dell PERC 10 Configuration Utility. See Navigating to Dell PERC 10 configuration utility.
2. Click Main Menu > Controller Management > Advanced Controller Management > Manage Controller Mode.
3. Click Switch to Enhanced HBA mode or Switch to RAID mode.
60
HII configuration utility